BRP Evinrude E-TEC Series, Service Manual, Page: 263 / 342

261
GEARCASE
GEARCASE ASSEMBLY
12
Driveshaft Seals
Apply Gasket Sealing Compound to the metal
casing of the seals before installing.
Use Seal Installer, P/N 326552, to install the inner
seal with flush lip facing into the gearcase, then
the outer seal with extended lip facing out of the
gearcase.
Apply Triple-Guard grease to the seal lips after
installing.
GEARCASE ASSEMBLY
Propeller Shaft, Gear and Shifter
Installation
IMPORTANT:
Make no dry assemblies. Lubri-
cate all bearings, shafts, and gears with gearcase
lubricant.
Oil and place the forward bearing cone and roller
assembly in the forward bearing cup.
Install the small thrust washer with the chamfered
inside diameter facing the pinion gear. Oil and
install the thrust bearing. Install the large thrust
washer with chamfered outside edge facing up.
1. Seal Installer, P/N 326552
2. Inner seal
3. Outer seal
DR2061
DR2062
1
2
3
38635
1. Small thrust washer, chamfered inside diameter
2. Thrust bearing
3. Large thrust washer, chamfered outside edge
803051
2
3
1