BRP Evinrude E-TEC Series, Service Manual, Page: 258 / 342

256
GEARCASE
BEARING AND SEAL REMOVAL
Use long-nose pliers to remove the clutch and
shifter lever assembly. Use no force. Tilting the
shifter lever slightly will allow you to remove it
from the gearcase.
Remove the forward bearing, forward gear, pinion,
pinion thrust bearing, and two pinion thrust wash-
ers.
BEARING AND SEAL
REMOVAL
IMPORTANT:
Inspect bearings for damage
while in place. If bearing is damaged, remove and
discard. If the bearing is removed for any reason,
it must be replaced.
Driveshaft Seals
Use Puller Bridge, P/N 432127, and Small Puller
Jaws, P/N 432131, to remove the two driveshaft
seals. Discard the seals.
Driveshaft Bearing
Use Puller Bridge, P/N 432127, and Small Puller
Jaws, P/N 432131 to remove the driveshaft bear-
ing and sleeve from the gearcase. Discard the
bearing.
1. Clutch
2. Shifter lever assembly
007677
007678
1
2
38633
38634