BRP Evinrude E-TEC Series, Service Manual, Page: 241 / 342

239
MIDSECTION
TILLER HANDLE SERVICE
11
Install shift handle. Install shift handle screw.
Tighten screw securely.
Installation
Place tiller bracket on steering arm.
Install screw and washer in front mounting hole.
The tiller handle angle can be set to center or
angled to port or starboard 20° .
Install rear washer and screw in appropriate loca-
tion.
Tighten both screws to a torque of 18 to 20 ft. lbs.
(25 to 27 N·m).
Install locknuts on screws.
Hold screws with a wrench and tighten locknuts to
a torque of 18 to 20 ft. lbs. (25 to 27 N·m).
Route tiller control wiring as shown.
1. Screw
2. Shift handle
007529
1. Screw
2. Washer
007460
007214
2 1
1
2
1. Screw
2. Washer
007461
3. Locknuts 007462
1
2
1