BRP Evinrude E-TEC Series, Service Manual, Page: 229 / 342

227
MIDSECTION
TILLER HANDLE SERVICE
11
TILLER HANDLE
SERVICE
Removal
Remove lower engine covers. Refer to Lower
Cover Removal on p. 45.
Disconnect tiller electrical connector and trim con-
nector, if equipped.
Use Ball Socket Remover Tool, P/N 342226, to
remove throttle cable connector from throttle
lever. Remove screw and washer from throttle
cable retainer.
Remove clip and washer from shift lever pin and
remove shift cable connector from shift lever pin.
Remove cable anchor screw and washer from
shift cable retainer.
Remove locknuts from screws on bottom of
steering arm.
Remove front steering handle screw and washer.
WARNING
To avoid accidental starting of engine
while servicing, twist and remove all spark
plug leads.
1. Tiller electrical connector 007474
1. Throttle cable connector
2. Throttle cable retainer
007471
1
1
2
1. Shift cable connector
2. Shift cable retainer
007467
1. Locknuts 007462
1. Front steering arm screw and washer 007460
1
2
1
1