BRP Evinrude E-TEC Series, Service Manual, Page: 205 / 342

203
MIDSECTION
EXHAUST HOUSING SERVICE
11
EXHAUST HOUSING
SERVICE
The exhaust housing contains no serviceable
internal parts. The exhaust relief muffler and
motor mounts can be serviced without removing
the exhaust housing.
Exhaust Housing Removal
Before removing the exhaust housing:
•
Remove the gearcase. Refer to GEARCASE
REMOVAL AND INSTALLATION on p. 248.
•
Remove the powerhead. Refer to POWER-
HEAD REMOVAL on p. 170.
Remove two upper mount and two lower mount
screws.
Remove bumpers and bumper stops from upper
mounts. Remove washers from lower mounts.
Remove the exhaust housing.
Remove lower mount bracket rubber mount.
Check condition of the lower front mount. Replace
if deteriorated or damaged.
Exhaust Housing Installation
Install lower mount bracket rubber mount.
Bring the exhaust housing into position with the
stern bracket.
Install bumpers, bumper stops and screws on
upper mounts. Install washers and screws on
lower mounts. Refer to
Mount Service on p. 204.
Install gearcase. Refer to GEARCASE REMOVAL
AND INSTALLATION on p. 248.
Install powerhead. Refer to POWERHEAD
INSTALLATION on p. 188.
1. Upper mount screw
2. Lower mount screw
007566
Exhaust Housing 007567
2
1
1. Rubber mount 007568
Exhaust Housing 007567
1