BRP Evinrude E-TEC Series, Service Manual, Page: 173 / 342

171
POWERHEAD
POWERHEAD REMOVAL
10
Remove water intake screens.
Remove the upper shift rod connector screw.
Install Universal Puller Set, P/N 378103 and Lift-
ing Eye, P/N 321537, on flywheel and seat the
three screws completely.
Fasten appropriate chain hook to eye of tool and
support weight of powerhead with hoist.
Remove the two exhaust housing to powerhead
nuts and six exhaust housing to powerhead
screws.
Use a suitable tool to carefully separate the pow-
erhead from exhaust housing.
IMPORTANT:
Do not damage the powerhead or
exhaust housing mating surfaces.
Remove clip from upper shift rod and remove shift
rod.
1. Water intake screen 007649
1. Shift rod connector screw 007650
1. Universal puller set
2. Lifting eye
007740
1
1
2
1
1. Powerhead nuts
1. Powerhead screws
007741
1. Clip
2. Shift shaft
007742
2
1
1
2