BRP Evinrude E-TEC Series, Service Manual, Page: 134 / 342

132
FUEL SYSTEM
FUEL COMPONENT SERVICING
Fuel Lift Pump Service
The fuel lift pump is serviceable as a complete
assembly. Refer to parts catalog for service parts.
Removal
Disconnect the battery cables at the battery.
Remove port lower motor cover. Refer to Lower
Cover Removal .
Remove the oil tank. Refer to Oil Tank Assembly
on p. 155.
Use an appropriate tool to remove the push nuts
that retain fuel pump to oil tank.
Remove the fuel hoses from the fuel pump hous-
ing.
Remove the fuel lift pump.
Installation
Connect the fuel hoses to the fuel pump. Secure
with
Oetiker clamps.
Place fuel pump in position on the oil tank. Secure
the fuel pump with new pushnuts, P/N 354365.
Be sure fuel hoses are routed in channels on oil
tank. Install the oil tank. Refer to
Oil Tank Assem-
bly on p. 155 .
Squeeze primer bulb to prime fuel system. Hold
pressure on bulb and check for fuel leaks.
Connect battery cables.
Run outboard and check for fuel leaks.
Vapor Separator and Fuel Injector
Service
Vapor Separator Removal
Relieve fuel system pressure. Refer to Relieving
Fuel System Pressure on p. 130.
Disconnect the battery cables at the battery.
Remove oil tank. Refer to Oil Tank Assembly on
p. 155.
1. Fuel pump housing 007410
1
1. Push nuts 007422
1