BRP Evinrude E-TEC Series, Service Manual, Page: 12 / 342

10
REFERENCE INFORMATION
SERVICE SPECIFICATIONS
SERVICE SPECIFICATIONS
15 HO Models 25 – 30 HP Models
ENGINE
Full Throttle
Operating Range RPM
15 HP – 5500 to 6100 RPM
25 HP – 5500 to 6100 RPM
30 HP – 5500 to 6100 RPM
Power 15 HP (11.2 kw) @ 5800 RPM
25 HP (30 kw) @ 5800 RPM
30 HP (37 kw) @ 5800 RPM
Idle RPM in Gear 750 ± 50 EMM Controlled
Idle RPM in Neutral 700 ± 50 EMM Controlled
Weight
(may vary depending
on model)
(DHPL) Models: 181 lbs. (82 Kg)
(DHTL) Models: 187 lbs. (85 Kg)
(R) Models: 152 lbs. (69 kg)
(RL) Models: 156 lbs. (71 kg)
(TE) Models: 166 lbs. (105 kg)
(TEL) Models: 170 lbs. (75 kg)
(DTL) Models: 191 lbs. (86 kg)
(DEL) Models: 164 lbs. (74 kg)
(PL) Models: 185 lbs. (84 kg)
Lubrication
Evinrude/Johnson XD100, XD50, XD30 ; or
NMMA TC-W3 certified
Engine Type In-line, 2 Cylinder, Two-Cycle
Displacement 35.1 cu. in. (575 cc)
Bore 2.992 in (76 mm)
Stroke 2.500 in. (63.50 mm)
Standard Bore
2.9916 to 2.9931 in. (75.989 to 76.026 mm)
To bore oversize, add piston oversize dimension to standard bore
Top Crankshaft Journal 1.6235 to 1.6245 in. (41.237 to 41.262 mm)
Center Crankshaft Journal 1.7461 to 1.7470 in. (44.350 to 44.375 mm)
Bottom Crankshaft Journal 2.0450 to 2.0459 in. (51.942 to 51.967 mm)
Rod Crankpin 1.1815 to 1.1817 in. (30.011 to 30.016 mm)
Piston Ring End Gap, Both 0.011 to 0.019 in. (0.30 to 0.50 mm)
FUEL
Fuel/Oil Control EMM Controlled
Starting Enrichment EMM Controlled
Minimum (High) Fuel Pressure 28 to 32 psi (193 to 220 kPa)
Minimum Fuel Lift
Pump Pressure
2 psi (14 kPa)
Maximum Fuel Inlet Vacuum 4 in. Hg.
Minimum Octane 87 AKI (R+M)/2 or 90 RON
Additives
2+4
®
Fuel Conditioner , Fuel System Cleaner
Use of other additives may result in engine damage.
See FUEL SYSTEM REQUIREMENTS on p. 120 for additional information