BRP Evinrude E-TEC Series, Service Manual, Page: 115 / 342

113
ELECTRICAL AND IGNITION
CONNECTOR SERVICING
6
Terminal Installation
Align terminal with connector housing. Push con-
nector and seal into housing until seated.
Align anti-backout device with connector housing
and terminals. Use Secondary Lock Installer,
P/N 777079, to seat device in connector.
Crimping Terminals
Crimping Superseal 1.5 terminals requires AMP
Crimp Tool with dies, P/N 777281.
S
UPER
S
EAL
The J1-A connector of the EMM is an AMP Super
Seal connectors.
Disconnect
Depress BOTH latches and pull connector from
plug.
Connect
Push connector into plug until latches engage.
Terminal Removal
Open lock mechanism and remove terminal from
connector housing.
Terminal Installation
Push terminal through seal until it is seated in con-
nector housing. Close lock mechanism.
1. Locking tab, plug
2. Locking tab, receptacle
002447
1. Terminal and seal 002451
1. Terminal
2. Seal
002452
2 1
1
1
2
1. Latch 007353
1. Latch
2. Lock mechanism
002453
1. Terminal 002454
1
2
1
2
1
1