BRP EVINRUDE E-TEC BE50DPLABA, Service Manual

Page: 115 / 422

115
ELECTRICAL AND IGNITION
FLYWHEEL AND STATOR SERVICING
6
Use Flywheel Holder, P/N 771311, or equivalent,
and a 1 5/16 in. socket to remove flywheel nut.
Discard flywheel nut.
Apply Moly Lube grease to the threads of the
puller pressing screw, P/N 307637, and the center
hole of the crankshaft.
Assemble the following components from Univer-
sal Puller Set, P/N 378103:
•
Body, P/N 307636
•
Screw, P/N 307637
•
Handle, P/N 307638
•
Three screws P/N 309492
•
Three washers, P/N 307640
Put the puller on flywheel with body flat side up.
Attach the puller body with the three shoulder
screws and washers. Hold puller body with han-
dle, and tighten pressing screw until flywheel
releases. Turn the center screw and lift the fly-
wheel off of the crankshaft.
Stator Service
Disconnect stator harness connector.
Remove three allen head screws to remove stator.
To install stator, position stator on cylinder block.
Apply
Nut Lock to screw threads. Install screws
and tighten in crossing pattern to a torque of 84 to
106 in. lbs. (9.5 to 12 N·m).
Flywheel Installation
Install the outer edge of flywheel key parallel with
centerline of crankshaft.
002088
1. Universal puller 002089
1
1. Stator screws 006486
A
WARNING
To avoid injury, keep hands and fingers
clear from underside of flywheel. Flywheel
can snap toward stator with great magnetic
force.
1. Flywheel key DRC2116
1
1