BRP E250DHLSCS, Service Manual

Page: 56 / 396

54
INSTALLATION AND PREDELIVERY
OUTBOARD RIGGING
CANbus Connections
If the outboard will be used with
I-Command
, or
other
NMEA 2000
compliant CANbus instruments,
the following connections will supply information
to the network.
Connect the
EMM
CANbus connector to the CAN-
bus Network Harness.
Use a CANbus Ignition Harness, in place of the
standard MWS harness, to connect the outboard
to the key switch and trim/tilt control. Seal unused
SystemCheck
connector with 6-Pin Connector
Seal, P/N 586076.
If installing a
Deutsch
-style
I-Command
network,
connect the purple wire from the CANbus Ignition
Harness to the CANbus network harness. This
connection supplies power to the network when
the key switch is on. Quick Connect-style network
does NOT use this connection.
Route the harnesses around the starboard side of
the powerhead along the same path as the battery
cables.
1.
EMM
CANbus connector
004265
1
1. CANbus Ignition connector
2. Trim/Tilt connector
3.
SystemCheck
connector (with seal)
4. CANbus power supply connector
006862
2
1
3
4