BRP E250DHLSCS, Service Manual

Page: 296 / 396

294
GEARCASE – STANDARD ROTATION
GEARCASE ASSEMBLY
Shift Rod Cover
Lubricate a new shift rod cover O-ring with
Triple-
Guard
grease. Install the O-ring into the shift rod
cover.
IMPORTANT:
Make sure O-ring is fully seated
in groove.
Install the shift rod spacer on the shift rod. On 30
in. models, first install the extension (not shown).
Place the shift rod grommet on the shift rod.
Apply
Triple-Guard
grease to the threaded end of
the shift rod and insert it through the cover. Turn
the shift rod while pushing it through the cover to
avoid damaging the O-ring.
“L2” T
YPE
G
EARCASES
Apply
Gasket Sealing Compound
to both sides of
a new shift rod cover gasket. Place the gasket on
the gearcase.
“M2” Type Gearcases
Apply
Adhesive 847
to seal groove of shift rod
cover. Place a new shift rod cover seal in groove.
A
LL
G
EARCASES
Thread the shift rod into the shifter detent about
four turns.
Move shift rod from side to side while pushing on
the propeller shaft to ensure proper alignment of
the bearing housing locator pin into the locator pin
hole in the gearcase.
1. O-ring
006916
1. Grommet
2. Shift rod spacer
006917
1
1
2
1. Cover gasket
COA3141
1. Cover seal
006918
1
1