BRP E250DHLSCS, Service Manual

Page: 281 / 396

279
GEARCASE – STANDARD ROTATION
GEARCASE DISASSEMBLY
13
Propeller Shaft Bearing Housing
Removal – “L2” and “M2” Type
IMPORTANT:
Identify gearcase type before dis-
assembly. For counter rotation gearcases, refer to
GEARCASE DISASSEMBLY
on p. 300.
The propeller shaft bearing housing on “L2” and
“M2” models is PRESSED into gearcase housing.
“L2” T
YPE
G
EARCASES
Remove the two screws, washers, and retainers
holding the propeller shaft bearing housing.
“M2” T
YPE
G
EARCASES
Remove the two screws holding the propeller
shaft bearing housing.
Remove the propeller shaft bearing housing from
the gearcase using:
•
Propeller Shaft Bearing Housing Puller Kit,
P/N 354060.
DO NOT use tools designed to push on the pro-
peller shaft. Pushing force against the propeller
shaft could damage the forward gear thrust bear-
ing or thrust washer.
IMPORTANT:
The L2 type gearcase uses the
adaptor ring included with puller kit.
Install the threaded adaptor from the puller kit on
to the propeller shaft until seated.
Assemble puller kit components. Hold adaptor
with wrench and turn nut clockwise to pull bearing
housing.
1. Retainer tab screws
001989
1. Retainer screws
006835
1
1
“M2” Type Gearcase
006833
006874