BRP E250DHLSCS, Service Manual

Page: 106 / 396

104
ENGINE MANAGEMENT MODULE (EMM)
DIAGNOSTIC SOFTWARE FUNCTIONS
Oil Control Settings
Set Oil Type
The TC-W3 oil type setting is the standard setting
for all outboards. Set TC-W3 for:
•
Operation with all TC-W3 outboard oils includ-
ing
XD30, XD50, or XD100
.
•
Applications requiring maximum lubrication.
•
Extreme applications (racing or harsh condi-
tions)
The
XD100
setting provides an option to run the
outboard at a reduced oil injection rate. This set-
ting REQUIRES the use of
Evinrude XD100
out-
board lubricant and is not recommended for all
applications.
Use the
XD100
setting for:
•
Conventional use (runabouts, cruisers)
•
Moderate applications
Powerhead Break-In
Use the diagnostic software to initiate break-in oil-
ing. Break-in is a predetermined oiling program
that runs for five hours of outboard operation,
above 2000 RPM.
1. Oil control setting
006805
CAUTION
Running an Evinrude E-TEC outboard on
other grades of oil while set to the XD100
oil ratio will result in increased engine
wear and shortened outboard life.
1
1. Break-in oil setting
006805
1