BRP E200DHLSEB, Service Manual

Page: 315 / 412

313
GEARCASE – STANDARD ROTATION
GEARCASE ASSEMBLY
13
the driveshaft by hand to thread the nut on to
shaft.
Apply
Gasket Sealing Compound
to the threads of
the driveshaft bearing housing screws. Tighten
screws
in stages
to a torque of 120 to 144 in. lbs.
(13.5 to 16.5 N·m).
Use Driveshaft Holding Socket, P/N 311875, Pin-
ion Nut Holder, P/N 334455, and Wrench
Retainer, P/N 341438, to tighten the pinion nut to
a torque of 100 to 110 ft. lbs. (136 to 149 N·m).
Pad handle of holder to prevent damage to gear-
case.
Propeller Shaft Bearing Housing
and Gear Installation – “L2” Type
IMPORTANT:
The propeller shaft bearing hous-
ing on the “L2” type gearcases is PRESSED into
the gearcase housing.
Oil and install thrust bearing and thrust washer on
hub of reverse gear.
006923
1. Driveshaft bearing housing screws
006876
1 1
1. Holding socket
2. Pinion holder
3. Retainer
006875
1. Thrust bearing
2. Thrust washer
006905
3
2
1
1 2