BRP E200DHLSEB, Service Manual

Page: 114 / 412

112
SYSTEM ANALYSIS
DIAGNOSTIC PROCEDURES
DIAGNOSTIC
PROCEDURES
Visual Inspections
Inspect wiring and electrical connections. Disas-
semble and clean all corroded connections.
Replace damaged wiring, connectors, or termi-
nals. Repair any shorted electrical circuits.
•
Refer to
ELECTRICAL HARNESS CONNEC-
TIONS
on p. 130.
•
Refer to
WIRING DIAGRAM
at the back of this
manual.
•
Refer to
CONNECTOR SERVICING
on p. 160.
Make sure all ground connections are clean and
tight. Refer to
GROUND CIRCUITS
on p. 132.
Inspect spark plugs for wear, oil fowling, or dam-
age. A rich or lean running condition or evidence
of internal engine damage could be identified by
the appearance of the spark plugs.
Check the fuse and the emergency stop switch
lanyard.
Diagnostic Software Inspections
Before running the outboard, use
Evinrude Diag-
nostics
software to review historical information
stored in the
EMM
.
Check the
Hard Faults
and
Stored Faults
screens
for current service codes. Correct any problems
and clear the codes before further troubleshoot-
ing. Refer to
Stored Service Codes (Faults)
on
p. 104.
On some models, the stored code screen will dis-
play detailed information about the operating con-
ditions of the engine at the time the code was set.
Review information about how the outboard has
been operated using the
Profiles
screens.
1. Main engine harness ground
2. Ground stud (battery)
005315
1
2
Stored Faults Review Screen
1. Detailed information
007136
RPM Profile
007199
1