BRP Can-Am Outlander 450 DPS 2022, Operator'S Manual

Page: 133 / 220

131
Tightening Torque
Drain plug
10 ± 1 Nm
(89 ± 9 lbf-in)
8. Bleed cooling system, refer to Fill-
ing and Bleeding the Cooling
System
.
F Fiilllliin ng g a an nd d B Blle ee ed diin ng g tth he e C Co oo olliin ng g
S Syysstte em m
1. Unscrew bleed screws above both
front and rear cylinders.
T TY YP PIIC CA AL L
1. Front cylinder bleed screw
T TY YP PIIC CA AL L
1. Rear cylinder bleed screw
2. Fill the cooling system until coolant
comes out of the bleed screw(s).
3. Squeeze the top of the coolant
hose between the radiator and
coolant pump several times until
all air is bled from the highest point
of the hose.
4. Install the bleed screw using a
N NE EW W gasket rings and tighten to
specification.
T Tiig gh htte en niin ng g tto orrq qu ue e
Bleed screws
5.0 ± 0.6 Nm
(44 ± 5 lbf-in)
5. Continue adding coolant until sys-
tem is full up to the pressure cap.
6. Refill coolant tank up to MAX level
mark.
7. Run engine at idle with the radiator
cap off. Slowly add coolant if
necessary.
8. At this point, wait until engine
reaches normal operating
temperature.
9. Depress the throttle lever two or
three times; then add coolant if
required.
10. Stop the engine and let it cool
down.
11. Install coolant reservoir cap.
12. Inspect all connections for leaks
and check coolant level in the
reservoir.
M Mu ufffflle err S Sp pa arrkk A Arrrre esstte err
The muffler must be periodically
purged of accumulated carbon.
W WA AR RN NIIN NG G
N Ne evve err rru un n e en ng giin ne e iin n a an n e en nccllo osse ed d
a arre ea a.. N Ne evve err p pe errffo orrm m tth hiiss o op pe erra a--
ttiio on n iim mm me ed diia atte ellyy a afftte err tth he e e en ng giin ne e
h ha ass b be ee en n rru un nn niin ng g b be ecca au usse e e exx--
h ha au usstt ssyysstte em m iiss vve erryy h ho ott.. M Ma akke e
ssu urre e tth ha att tth he erre e a arre e n no o cco om mb bu ussttiib blle e
m ma atte erriia allss iin n tth he e a arre ea a.. W We ea arr e eyye e
p prro otte eccttiio on n a an nd d g gllo ovve ess.. N Ne evve err
sstta an nd d b be eh hiin nd d tth he e vve eh hiicclle e w wh hiille e
p pu urrg giin ng g e exxh ha au usstt ssyysstte em m.. R Re essp pe ecctt
a allll a ap pp plliicca ab blle e lla aw wss a an nd d
rre eg gu ulla attiio on nss..
Select a well-ventilated area and
make sure the muffler is cool.
Place gearbox on PARK position.
Remove the clean out plug of the
muffler.
MAINTENANCE PROCEDURES