BRP Can-Am Outlander 450 DPS 2022, Operator'S Manual

Page: 129 / 220

127
12. Refill engine at the proper level
with the recommended oil.
Refer to Technical Specifications
for oil capacity.
13. Start engine and let idle for a few
minutes.
14. Ensure oil filter area and oil drain
plug areas are not leaking.
15. Stop engine.
16. Wait a while to allow oil to flow
down to crankcase then check oil
level.
17. Refill as necessary.
18. Dispose of oil as per your local en-
vironmental regulations.
E En ng giin ne e O Oiill F Fiilltte err
R Re em mo ovviin ng g tth he e O Oiill F Fiilltte err
Clean oil filter area.
Remove oil filter cover.
Remove oil filter.
T TY YP PIIC CA AL L
1. Oil filter screw
2. Oil filter cover
3. O-ring
4. Oil filter
IIn nsstta alllliin ng g tth he e O Oiill F Fiilltte err
1. Check and clean the oil filter inlet
and outlet area for dirt and other
contaminations.
1. Inlet bore from the oil pump to the oil filter
2. Outlet bore to the engine oil providing
system
2. Install a NEW O-ring on oil filter
cover.
3. Install the new filter into the cover.
4. Apply engine oil on O-ring and
grease on the end of filter.
1. Slightly oil
2. Slightly oil
N NO OT TIIC CE E
P Pa ayy a atttte en nttiio on n tto o a avvo oiid d p piin ncch hiin ng g
tth he e O O--rriin ng g d du urriin ng g ffiilltte err a an nd d cco ovve err
iin nsstta alllla attiio on n..
5. Install the cover on the engine.
6. Tighten oil filter cover screws to
recommended specification.
T Tiig gh htte en niin ng g T To orrq qu ue e
Oil filter cover
screws
10 ± 1 Nm
(89 ± 9 lbf-in)
7. Wipe off any oil spillage on engine.
MAINTENANCE PROCEDURES