BRP BOMBARDIER DS250 2006, Shop Manual

Page: 11 / 284

INTRODUCTION
INTRODUCTION
GENERAL INFORMATION
This Shop Manual covers the following 2006 ATV
models:
MODEL
MODEL
NUMBER
DS 250 CE
(European Community models)
3J6B
DS 250 (North America and
International models)
3J6C
The use of RIGHT and LEFT indications in the text,
always refers to driving position (sitting on the ve-
hicle).
The information and component/system descrip-
tions contained in this manual are correct at time
of publication. BRP, however, maintains a policy
of continuous improvement of its products with-
out imposing upon itself any obligation to install
them on products previously manufactured.
Due to late changes, it may have some differences
between the manufactured product and the de-
scription and/or specifications in this document.
BRP reserves the right at any time to discontinue
or change specifications, designs, features, mod-
els or equipment without incurring obligation.
VEHICLE SERIAL NUMBER
LOCATION
1
2
vmo2006-014-004_a
1. V.I.N. (Vehicle Identification Number)
2. Model number
ENGINE SERIAL NUMBER
LOCATION
vmo2006-014-005_a
E.I.N. (ENGINE IDENTIFICATION NUMBER)
ARRANGEMENT OF THE
MANUAL, ILLUSTRATIONS
AND PROCEDURES
The manual is divided into many major sections as
you can see in the main table of contents at the
beginning of the manual.
Each section is divided in various subsections, and
again, each subsection has one or more division.
Illustrations and photos show the typical construc-
tion of the different assemblies and, in all cases,
may not reproduce the full detail or exact shape of
the parts shown, however, they represent parts
that have the same or a similar function.
CAUTION: Most components in the vehicles
are built with parts dimensioned in the metric
system. Most fasteners are metric and must
not be replaced by customary fasteners or
vice-versa. Mismatched or incorrect fasteners
could cause damage to the vehicle or possible
personal injury.
VIII
vmr2006-060