ADJUSTMENTS
smr2009-036-011_a
1. Read Data
2. Vehicle tab
3. Reset Service/”Maint” button
4. Reset Supercharger Maintenance button
When done, click on FAULT tab and check if there
are active faults.
– If so, service watercraft then clear the faults in
B.U.D.S.
NOTICE
After a problem has been solved, en-
sure to clear fault(s) in ECM. This will properly
reset appropriate counter(s).
Click on WRITE DATA button to transfer new set-
tings and information.
Click on EXIT button (rightmost) to end session.
Disconnect all cables and hardware from vehicle.
Ensure to reinstall cap over the communication
connector and all vehicle parts.
ADJUSTMENTS
Steering Alignment
Install two bungee cords to maintain steering dur-
ing the procedure.
Position steering so that the edge of the steering
column cover and edge of the gauge support are
equal.
smr2009-037-055_a
1. Steering column cover edge
2. Gauge support edge
Check jet pump nozzle position by placing a
straight edge on nozzle outer end. Measure the
distance on each side of the straight edge. It
must be equalled.
smr2009-037-003_a
1. Straight edge places against nozzle
If necessary,
steering alignment adjustment
should be performed at steering column.
Open storage compartment cover and remove
basket.
Loosen steering column clamp bolts securing the
steering cable clamp at the bottom of steering col-
umn.
Turn adjusting nut as required.
smr2009-042-007_a
1. Steering column
2. Steering column clamp bolts
3. Steering column clamp
4. Steering cable adjusting nut
20 / 23
2009-3
PREDELIVERY
