B.U.D.S. PROGRAMMING
Click the
Write Data
button.
vmr2006-012-100_ben
After the write operation, remove key from
D.E.S.S. post.
Try the key(s) on the watercraft.
Setting Maximum Speed for Learning and
Rental Keys
To change Learning or Rental Key settings, refer
to the
OPERATOR'S GUIDE
.
Information Center Setup
Briefly press start/stop button to power the ECM.
Engine must not crank.
NOTE:
Press the start/stop button every three
minutes or the electrical system will shut off.
Select the
Read Data
button.
Choose the
Setting
tab at the top of the page.
At the bottom LH side of the setting page, select
the
Cluster
tab.
smr2009-036-001_a
1. Read Data
2. Setting tab
3. Cluster tab
In the
Cluster Language
field, choose the desired
unit of language,
English
,
French
or
Spanish
.
In the
Cluster Units
field, choose the desired unit
of measurement,
Imperial
or
Metric
.
smr2008-028-002_a
1. Cluster Language field
2. Cluster Units field
Unlock iS Suspension
The iS suspension is locked in B.U.D.S. and will
not move until you click on the
UNLOCK iS
but-
ton.
sbl2009-004-055_a
ACTIVATION AND IBR TABS
1. UNLOCK iS button
Ending a B.U.D.S. Session
Before ending the B.U.D.S. session, you need to
clear the maintenance reminder indicators.
Choose the
Vehicle
tab at the top of the page.
At the bottom RH side of the vehicle page
in the
Last Service
field, choose
Reset Ser-
vice/”Maint”
button.
PREDELIVERY
2009-3
19 / 23
