43
5.2 Self-test and Dump Mode
The printer calibrates the sensor, detects the media length, prints internal settings,
and then enters the dump mode.
To perform the printer self-test and enter dump mode:
1. Turn off the printer.
2. Press and hold the
Feed/Pause
button (
) and then turn on the printer.
3. Release the
Feed/Pause
button when the printer's Status LED changes to
and starts blinking.
The LEDs will change as follows:
(Orange)
(5 times)
(5 times)
(5 times)
(Green (lit))
To resume printing, turn the printer off and then on again.
The self-test information is printed automatically.
Release the
Feed/Pause
button to
perform the printer self-test and
enter dump mode.
Summary of Contents for RJ-2035B
Page 62: ......