Brother Innov-is NV4000D, Service Manual

Page: 272 / 381

3 - 140
Embroidery Main parts
12
FFC support ASSY assembly
1. Bend the FFC cord
1
(50 mm from the tip) with the black line facing out.
2. Insert the end of the FFC cord
1
into the guide
3
on the FFC support
2
,
and pull the tip of the FFC cord
1
until the black line passes through the
guide
3
.
3. Insert the end of the FFC cord
1
into the guide
4
on the FFC support
2
,
and pull the tip of the FFC cord
1
until a fold is created in the black line
between the guide
3
and the guide
4
.
4. Insert the other end of the FFC cord
1
into the guide
6
and then pull the
tip of the FFC cord
1
until a fold
7
is created immediately before the
guide
6
.
*Key point
• Insert the other end of the FFC cord into the guide 6 with the
rear of the cord (surface without the blue tag) facing you so
that a fold is created as shown in the illustration on the right.
5. Fold the FFC cord back to the left at the exit of the guide
6
.
6. Fold the other end of the FFC cord
1
with the black line facing in, and
fold it back at a point 20 mm from the black line to create an N-shape.
1
2 3
4
5
7 6
1