Brother HL-S7000DN Series, Service Manual

Page: 432 / 460

5-44
Confidential
1.4.19 Frame pattern print (One-sided) (Function code 69)
<Function>
This function allows you to print one page of the frame pattern of the external circumference in
one-sided printing and check if there is any deviation or omission of print.
<Operating procedure>
Before starting the following procedure, set a letter-size paper on which test pattern is printed.
(1) Press the 6 and 9 buttons in this order in the initial state of the maintenance mode.
"PRINTING" is displayed on the LCD, and one page of the frame pattern (refer to the
figure below) in one-sided printing.
(2) When print is completed, "WAKU SX" is displayed on the LCD.
If printing fails, the following error indications are displayed and printing is cancelled.
To print again, refer to the measures in the table below and remove the cause of the error.
Then, press the
Go button.
"WAKU SX" is displayed on the LCD, and press the OK button.
"PRINTING" is displayed on the LCD, and one page of the frame pattern is printed on
one-side of paper.
(3) To print the frame pattern again, press the OK button.
(4) To return the machine to the initial stage of the maintenance mode, press the Cancel
button.
Fig. 5-26
LCD Measure
Cover is Open Close the front cover.
No Paper Load paper and close the paper tray.
Jam Tray1 Remove jammed paper and close the paper tray.
Jam Rear Remove jammed paper and close all covers.