Brother HL-4000CN, Service Manual

Page: 261 / 345

V-51
4.9 Installation Setting
Function: Setting parameters at printer installation and displaying various counter values
Operation procedure:
1. Enter the Diag. (C/E) mode.
2. Select [CE Maintenance Installation Set] with the and buttons.
3. Press the Form Feed/Set button to advance to setting/display item selection in [CE
Maintenance Installation Set].
4. Select a setting/display item with the and buttons. (For the setting/display
items, refer to the table below.)
5. Press the Form Feed/Set button to display the setting/display item.
Setting/display items
Item Range Description
Serial No. 10 digits Sets a serial number.
Count Display ON, OFF Sets whether to display the billing counter.
Configuration (*1) Change the Dip Switch setting on NVM.
Col print Count Displays the current value of the color print counter.
B/W Print Count Displays the current value of the monochrome print
counter.
Tot Print Count Displays the current value of the total print counter.
Backup Col Count Displays the current value of the backup color counter.
Backup B/W Count Displays the current value of the backup monochrome
counter.
Backup Tot Count Displays the current value of the backup total counter.
Col Error Count Displays the current value of the color print error
counter.
B/W Error Count Displays the current value of the monochrome print
error counter.
PrnCounter Reset Initializes three counter values (clears to zero).
Count copy M to B Copies from a normal meter to a backup file.
NVM Init Initializes NVM
Job Log Init Initializes Job Log
*1 Dip Switch 0
For service engineer
Bit Function Description
0 Hex Dump mode
0=OFF
1=ON
1 EEPROM Clear
0=OFF
1=ON
Clear all history except Network.
2 7 Not Used
Dip Switch 1: For debug
Dip Switch 2: For debug
Dip Switch 3: Not Used