2-7
Windows NT Print Queue Configuration
Windows NT 4.0 Print Queue Configuration (Printer Driver already installed)
✒
Note
If you have Windows NT 3.5 or 3.51, skip to the Windows NT 3.5x section.
If you have already installed the appropriate Brother printer driver do the following:
1.
Click on Start then select Settings/Printers to display the currently installed printer
drivers.
2.
Double click the printer driver you wish to configure and select Printer menu and then
choose Properties.
3.
Select the Ports tab and click on Add Port.
4.
Select LPR Port (LPR Port will not be displayed unless you install the "Microsoft
TCP/IP Printing" protocol as described earlier) from the list of
available ports and
click on New Port.
5.
Type in the IP address that you assigned to the print server in the Name or address of
server providing lpd: box. If you have edited your
HOSTS
file or are using Domain
Name System, you can enter the name associated with the print server, instead of an IP
address. As the print server supports TCP/IP and NetBIOS names, you can also enter
the NetBIOS name of the print server. The NetBIOS name can be seen in your print
configuration sheet. From default the NetBIOS name will appear as “BRN_xxxxxx”
where xxxxxx is the last six digits of the Ethernet address.
6.
Type in the print server service name in the Name of printer or print queue on that
server: box. If you do not know which service name to use, enter
BINARY_P1
and then
click on OK:
7. Click on the Close button.
8. You should now see that the printer driver is configured to print to the IP address
(or name) that you specified.
9. If you wish to share the printer, click on the Share tab and share the driver.
