1.
Rotate your hook assembly so that the positioning guide is at the highest point during rotation.
2.
Attach your hook holder to your sewing machine with a M5 X 10 FHCS (don’t tighten the screw
during this step) with the hook holder’s finger in the middle of the hook assembly’s positioning guide.
3.
Slide your hook holder away from the hook assembly so there is about a 0.75mm gap (Make sure
the hook holder is in the Hook Assembly Positioning Guide securely with a gap between hook holder
and hook assembly) between the hook holder and the hook assembly, and tighten the M5 X 10 FHCS
.
Note:
Adjust the hook holder only if receiving a replacement part, removing your hook assembly or
part gets bumped out of place.
The Hook Holder
Parts Needed:
1.
3mm Allen Wrench
Hook Holder
Hook Assembly
0.75mm Gap
between Hook
Holder and Hook
Assembly
Hook Assembly
Positioning
Guide
M5 X 10 FHCS
24
