Brother DCP-T520W, Online User'S Manual, Page: 256 / 496

If you are using a Windows 7, Windows 8.1, or Windows 10 computer as a Registrar, complete the
following steps:
7. Do one of the following:
• Windows 10
Click > Windows System > Control Panel . In the Hardware and Sound group, click Add a device .
• Windows 8.1
Move your mouse to the lower right corner of your desktop. When the menu bar appears, click
Settings >
Control Panel > Hardware and Sound > Devices and Printers > Add a device .
• Windows 7
Click (Start) > Devices and Printers > Add a device .
• To use a Windows 7, Windows 8.1, or Windows 10 computer as a Registrar, you must register it to your
network in advance. For more information, see the instructions supplied with your wireless LAN access
point/router.
• If you use Windows 7, Windows 8.1, or Windows 10 as a Registrar, you can install the printer driver
after the wireless configuration by following the on-screen instructions. To install the driver and software
necessary to use your machine, go to your model's
Downloads page at support.brother.com .
Use the Brother installation disc to set up your machine (not available in all countries).
8. Select your machine and click Next .
9. Type the PIN displayed on the machine's LCD, and then click Next .
10. (Windows 7) Select your network, and then click Next .
11. Click Close .
MFC-T920DW/MFC-T925DW
1. Press Settings .
2. Press
a
or
b
to make your selections:
a. Select
[Network]
. Press OK .
b. Select
[WLAN(Wi-Fi)]
. Press OK .
c. Select
[WPS/PIN Code]
. Press OK .
3. When
[Enable WLAN?]
appears, press
c
.
The wireless setup wizard starts. To cancel, press
d
.
4. The LCD displays an eight-digit PIN and the machine starts searching for a wireless LAN access point/router.
5. Using a computer connected to the network, in your browser's address bar, type the IP address of the device
you are using as the Registrar. (For example: http://192.168.1.2)
6. Go to the WPS settings page and type the PIN, and then follow the on-screen instructions.
• The Registrar is usually the wireless LAN access point/router.
• The settings page may differ depending on the brand of wireless LAN access point/router. For more
information, see the instructions supplied with your wireless LAN access point/router.
If you are using a Windows 7, Windows 8.1, or Windows 10 computer as a Registrar, complete the
following steps:
7. Do one of the following:
• Windows 10
Click > Windows System > Control Panel . In the Hardware and Sound group, click Add a device .
• Windows 8.1
Move your mouse to the lower right corner of your desktop. When the menu bar appears, click
Settings >
Control Panel > Hardware and Sound > Devices and Printers > Add a device .
• Windows 7
250