Brother DCP Series, Service Manual

Page: 225 / 309

5-3 Confidential
1.1.2 How to Enter the End User-accessible Maintenance Mode
Basically, the maintenance-mode functions should be accessed by service personnel only.
However, you can allow end users to access some of these under the guidance of service
personnel (e.g., by telephone). The user-accessible functions are shaded in the table given
on the next page. (Maintenance mode
10, 11, 12, 17, 37, 52, 53, 54, 58, 65, 66, 75,
76, 77, 78, 80, 82, 87, 88, 91)
Touch panel model
<Operating Procedure>
(1) When the machine is on standby, hold down [Home] for approx. five seconds. The
following screen will be displayed on the LCD.
(2) Hold down the blank area at the bottom of the LCD for approx. two sec. The following
screen will be displayed on the LCD.
(3) Press [*], [0], and [#] on the LCD in this order. The machine becomes ready to accept
entry from the keys. Enter the desired maintenance code.
(4) When each of the maintenance mode functions is completed, the machine
automatically returns to standby.
Note To stop the procedure midway and return the machine to standby, press [Stop] or
[X].