5-20
Confidential
1.3.12 Set PC print functions (function code: 43)
<Function>
This function is used to change the settings of the various print functions summarized in the
table below.
<Operating Procedure>
Setting functions
LCD
Description
Set value
Default
Manual Feed
Manual feed setting
On/Off
Off
Resolution
Print resolution
300/600/1,200 dpi
600 dpi
Toner Save
Toner save mode setting
On/Off
Off
Density
Density (printing density) level
setting
-6 to 6
0
JB-Can Time
Time until host timeout after a job
is canceled
0 to 225 seconds
4 seconds
Sleep Time
Time until sleep mode is entered 0 to 99 minutes
5 minutes
Page Protection
Page memory setting
Off/Letter/A4/Legal/Auto Off
Emulation
Emulation (print language)
setting
Auto/HP/PS
Auto
Auto I/F Time
Interface open time setting
1 to 99 seconds
5 seconds
Media Type
Paper type setting
Thin/Plain/Thick/
Thicker/Trancparency/
Recycled/Bond/
Envlopes/EnvThin/
EnvThick
Plain or Thin
Paper Size
Image development area setting Letter/Legal/A4/
Executive/ISOB5/JISB5/
A5/ISOB6/A6/Monarch/
C5/COM10/DL/DLL/
A4Long/Postcard/Folio
Letter or A4
Copies
Number of copies
1 to 99 copies
1 copy
For models without keypad
(1) Press the [
▲
] or [
▼
] key in the initial
state of maintenance mode to display
"MAINTENANCE 43" on the LCD, and
press the [OK] key. "Manual Feed" is
displayed on the LCD.
(2) Press the [
▲
] or [
▼
] key to display the
function you want to change the setting
of, and press the [OK] key.
(3) For fixed parameters (On/Off, etc.),
press the [
▲
] or [
▼
] key to display the
setting you want to apply, and press the
[OK] key.
(4) When the [Stop] key is pressed, the
machine returns to the initial state of
maintenance mode.
For models with keypad
(1) Press the [4], and then the [3] key in the
initial state of maintenance mode.
"Manual Feed" is displayed on the LCD.
(2) Press the [
▲
] or [
▼
] key to display the
function you want to change the setting
of, and press the [SET] or [OK] key.
(3) For fixed parameters (On/Off, etc.),
press the [
▲
] or [
▼
] key to display the
setting you want to apply, and press the
[SET] or [OK] key. For parameters
requiring numerical value entry, use the
keypad to enter a numerical value
directly, and press the [SET] or [OK] key.
(4) When the [X] or [Stop] key is pressed,
the machine returns to the initial state of
maintenance mode.