Brother ADS-2600W, Service Manual

Page: 41 / 159

2-15
Confidential

Error code 3C00 to A100
These errors do not usually occur during normal use. The possible causes are noise around
the installation site, fluctuation of the power supply voltage, and failures in the software.
An unidentified error occurred.
 Error code A200
The document scanning position sensor detected that the document length was 40 cm or
more while scanning a document.
 Error code A300
The document scanning position sensor has not detected the top of the document even after
the document has been fed for the specified distance.
---
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.
Document Jam/too Long
See Troubleeshooting in Use's Guide.
<User Check>
• Set the document length within the standard.
Step Cause Remedy
1
Document scanning position
actuator caught in sections of
the machine Reattach the document scanning position
actuator.
2
Document scanning position
sensor failure Replace the document scanning position
sensor PCB ASSY.
3 Main PCB failure Replace the main PCB ASSY.
Document Jam/too Long
See Troubleeshooting in Use's Guide.
<User Check>
• Set the document in the ADF correctly.
Step Cause Remedy
1
Document scanning position
actuator coming off Reattach the document scanning position
actuator.
2
Document scanning position
sensor failure Replace the document scanning position
sensor PCB ASSY.
3 Main PCB failure Replace the main PCB ASSY.