Brother ADS-2600W, Service Manual, Page: 144 / 159

5-15
Confidential
1.3.12 Adjust touch panel (function code: 61)
<Function>
This function is used to adjust the detection area on the touch panel.
<Operating Procedure>
(1) Press the [6], and then the [1] key in the initial state of maintenance mode. The adjustment
screen shown below appears on the LCD.
(2) Use a touch panel stylus and touch the mark at the upper left corner of the screen. The
mark disappears when touched, then touch the mark at the lower left. Similarly touch the
mark at the lower right, upper right, and center.
(3) When the center (5th mark) is touched, [OK] is displayed if the specified area was
adjusted correctly. The machine returns to initial state of maintenance mode.
Note:
• This adjustment requires a touch panel stylus with a thin tip. A commercially available
stylus designed for electronic dictionaries or personal digital assistance (PDA) can be
used. If one is not available at hand, order a "STYLUS" from Brother's parts list.
Note:
• Do not use any tools other than a touch panel stylus. In particular, never use a pointed
tool (e.g. screwdriver). Using such a tool will damage the touch panel.
• Do not touch the touch panel with your fingers. The contact area of a finger is too large
to adjust the touch panel precisely.
• If no operation is performed for one minute or the button is pressed, the machine
returns to the initial state of maintenance mode.
Note:
• If "NG" is still displayed even after this operation is repeated two to three times, replace
the panel ASSY.