BrookVent AF 90-CYC-ONE-100, Installation, Maintenance & User Manual

Page: 6 / 20

5/19
disconnection under overvoltage category III conditions (contact opening
distance equal to or greater than 3mm).
✓
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualifi ed persons to avoid a hazard.
✓
Do not obstruct the fan or exhaust grille to ensure optimum air passage.
✓
Ensure adequate air return/discharge into/from the room in compliance with
existing regulations in order to ensure proper device operation.
✓
If the environment in which the product is installed also houses a fuel-
operating device (water heater, methane stove etc., that is not a “sealed
chamber” type), it is essential to ensure adequate air intake, to ensure good
combustion and proper equipment operation.
✓
Install the product so that the impeller is not accessible from the air outlet side
as verified by contact with the Test Finger (test probe “B” of the norm EN61032)
in compliance with the current safety regulations.
2.2 Responsibility of the Installer
✓
Correct Installation, balancing and commissioning of the unit.
✓
Compliance to requirements and local additional rules.
✓
Explanation of the ventilation system to the user.
✓
Warning for the user, to check or replace the air filters on time.
2.3 Responsibility of the Occupant
✓
To ensure maintenance of the ventilation unit on a regular basis. Filters should be
checked, cleaned or replace every 6 months. Details can be found on page 15
(maintenance).
✓
To ensure that the fan is operating. The aircycle ONE ventilation units are designed
to operate 24/7.