BrookVent AF 90-CYC-ONE-100, Installation, Maintenance & User Manual

Page: 10 / 20

9/19
OPTION 2 : If two or more units are not connected under the same main switch, to reset
the synchronisation, press at the same time the black pin of each unit (fig. 33) for at least
3 seconds.
If two or more units are controlled by means of the same controller (Air Controller or
similar), they always operate in a synchronised way.Wiring diagram as per fig. 18D
4.2 Jumper positions
Intergal jumper set in position A (fig. 20A) means “extract - only” mode. Intergal jumper set
in position B (fig. 20B) means “intake - only” mode.
The jumper position defines both the air -flow direction when the unit is activated for the
first time (for the synchronisation) and the air -flow direction of the free- cooling mode.
4.3 Disposal and recycling
Information on disposal of units at the end of life.
This product complies with EU Directive 2002/96/EC.
The symbol of the crossed-out dustbin indicates that this product must be collected
separately from other waste at the end of its life. The user must, therefore, dispose of the
product in question at suitable electronic and electro-technical waste disposal collection
centres, or else send the product back to the retailer when purchasing a new, equivalent
type device.
Separate collection of decommissioned equipment for recycling, treatment and
environmentally compatible disposal helps to prevent negative effects on the
environment and on health and promotes the recycling of the materials that make up the
equipment.
Improper disposal of the product by the user may result in administrative
sanctions as provided by law.