Fold
Fold
Fold
Fold
LOCATION OF PARTS AND
CONTROLS
PAIRING YOUR DEVICE
1. Press and hold the Power Button for
3 seconds to power on the
headphones. The blue light will
illuminate.
2. If the Button is pressed and held, the
headphones will search for
Bluetooth
®
enabled devices. The red
and blue lights will flash alternatively.
3. Once the headphones are in pairing
mode and your device is ready to
pair, select ‘Brookstone Headphones.’
If prompted, use 0000 as a PIN for
the pairing code. Once the
headphones are selected, a beep
tone will sound and the blue light
will flash.
NOTE:
If the headphones were powered on
and without Bluetooth
®
connection for
3 minutes, they will auto shut off. After
a successful connection, the blue LED
will flash three times every 5 seconds
(Bluetooth
®
connected but not playing
music)
1. Power Button
2. Volume Up/Track Backward Button
3. Volume Down/Track Forward Button
4. Microphone
5. Audio Cable Port
6. Micro USB Charging Port
7. Micro USB Charging Cable
(not shown)
8. Audio Cable (not shown)
9. Travel Pouch (not shown)
306612
1
2
4
5
6
3
Merrimack, New Hampshire, USA 03054
800-846-3000 • Brookstone.com
LITHIUM-ION BATTERY
WARNINGS
This device contains a non-removable
lithium-ion battery. The battery must be
recycled or disposed of properly.
Contact your local waste management
office for information on battery
recycling or disposal.
FCC INFORMATION
This equipment has been tested
and found to comply with the
limits for a Class B Digital Device,
pursuant to Part 15 of the FCC
Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the distance between the
equipment and receiver.
• Connect the equipment to an outlet
on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
This equipment complies with Part 15
of the FCC Rules. Operation is subject
to the following two conditions:
1. This equipment may not cause
harmful interference.
2. This equipment must accept any
interference received, including
interference that may cause
undesired operation.
Modifications not authorized by the
manufacturer may void the user’s
authority to operate this device.
FCCID: 2AF8E-WL-2706
