Bronkhorst®
Instruction Manual ES-FLOW™
9.17.116B
24
The following parameters are available in the
Setup
sub menu:
Parameter
Description
Supported values
Usertag
Custom instrument name
text (16 positions)
Serial
Instrument serial number
n/a (read only)
Model
Instrument model number
n/a (read only)
Firmware instr
Firmware version instrument
n/a (read only)
Firmware bright
Firmware version readout and control unit
n/a (read only)
Info top
Information to show in the top line of the display
·
usertag
·
serial number
Info bottom
Information to show in the
Custom readout 2
area
·
setpoint
·
valve
·
disabled
Setpoint
Specifies if the setpoint is edited as digits or step-wise
·
cursor
·
step
Brightness
Screen brightness
0 ... 9
Screen saver
Enable or disable screen saver
·
dimmer
·
off
Saver time
Number of minutes of inactivity before screen saver
becomes active
1 ... 99
Switch lock
Enable or disable switch lock
·
enabled
·
disabled
Lock time
Number of seconds of inactivity before switches are locked
0...600
Unlock time
Number of seconds to hold buttons to unlock switches
2...100
Bus (Bus 1 and 2)
Fieldbus type
n/a (read only)
Medium (only Bus 2)
Communication type
·
rs232
·
rs485
Baudrate (Bus 1 and 2)
Communication speed
fieldbus dependent
Instr node (Bus 1 and 2)
Primary node address on the fieldbus
fieldbus dependent
3.3.3.6 Advanced
In the
Advanced
sub menu, the following parameters can be edited:
Parameter/function
Description
Supported values
Dynamic filter
0…1
Static filter
0…1
Autozero
Function for adjusting zero point (only for flow
meters/controllers)
Restore
Function for restoring instrument settings
