16
10. Fuse
The fuse (9) is located on the rear of the unit. Sand-filled fuses with value 3.15 AF may
only be used (sand-filled fuses can be identified by their opaque fuse container). Using
wrong fuses is dangerous; it may cause the halogen lamp to burst. Original broncolor
replacement lamps are therefore delivered with the correct fuse.
11. Gasic settings eN OoSUs
The basic settings ex works can be viewed and in some instances changed with the
following procedure:
When the unit is switched on, simultaneously press the "mod” (5) and "aux” (10) keys for
approx. 5 seconds (the LED array "prop” / "seq” / "dim” / "buz” / "slow” / "unit” blinks to
indicate that you are in the programming mode).
Additionally the LED of the "mod” (5) key is lit. The digital display (17) shows the function
number 0. The other function numbers can be selected by pressing the energy control
keys "up/down” (18).
By briefly pressing the "aux” key, the digital display shows the actual value or the actual
setting within the selected function number. The LED of the "mod” key does not light up
in this mode. Within the function numbers 1, 2, 3 and 9, the settings can be changed with
the energy control keys "up/down”.
Concerning the function numbers 0 and 4 – 8, the different pairs of these multiple digit
values can be shown by means of the energy control keys "up/down”.
Return to normal operation by pressing (1 s) the "aux” key, by switching the unit off and
on again or automatically after a period of 20 seconds.
Function numZeS Meaning and possiZle settings
0
Program version:
Standard display
Program number: after pressing the energy control "down" key
1
Control range flash energy:
Setting ex work: "off" (--).
Display "on": the control range of the flash energy is extended to 5
f-stops (10 - 5.0)
2
Sensitivity of the photocell:
Setting ex work: "on".
This function reduces the sensitivity of the photocell. If the function
is activated the digital display shows the value "off"
3
Definition function "ir/rf":
Setting ex work: digital display shows the value "3"
¤ IR receiver and RFS Interface (if available) activated
Display value "1" ¤ only IR receiver activated
Display value "2" ¤ only RFS Interface activated
