Page 8
6.3
SWITCHING THE LAMP ON AND OFF
Firstly, connect the pigtail of the LED F160 lamp to the cable permanently attached to the power supply unit.
Now connect the supplied power cable to the power supply unit.
Then plug the mains plug into a suitable socket.
The display illumination is now activated and the LED F160 lamp is ready for use.
With a short press on the on/off button (
), the LED lights up and can be switched off in the same way ("standby").
Unplug the mains plug from the socket to switch off the device. The display only goes out completely once the power supply is
interrupted. The mains plug is used as a disconnect device, the disconnect device shall remain readily operable.
6.4
USE WITH A STAND
If desired, mount the LED F lamp on a suitable stand. The stand mount is located on the underside of the device.
6.5
CEILING INSTALLATION
WARNING!
For ceiling installation, please observe the mounting instructions supplied with the accessory
"33.173.00 - Safety cable for LED F160 lamp", which is available separately.
The LED F160 lamp must NOT be mounted on the ceiling without the safety cable mentioned above!
The display of the LED F160 lamp has an automatic orientation. In overhead operation, the display automatically rotates by 180°.
