Page 13
10.4
WIFI
Here, you can adjust the following values:
- switch on WiFi ("on")
- switch off WiFi ("off")
- perform a reset of the WiFi module ("reset")
- set the studio address
- activate automatic firmware updates ("Auto update") or disable them ("off")
Furthermore, the respective SSID the lamp is currently connected to, is being displayed here as well.
The studio address can have a value between 1 and 99.
10.5
DISPLAY
Adjusting the display orientation is the purpose of this submenu:
- "Auto":
Thanks to a sensor, the display will rotate by 180 degrees as soon as the lamp is upside down
- "0 DEG":
Now, the display will no longer rotate automatically (intended for stand mount)
- "180 DEG":
Now, the display will no longer rotate automatically (intended for ceiling installation)
10.6
INFO
Here, you can read the firmware version currently installed on the device.
11.
ERROR MESSAGES
If a device malfunction occurs, the two cognition lights will permanently light up red. The cause of the malfunction is shown as
plain text on the display.
12.
MAINTENANCE / REPAIRS
Your broncolor LED F160 lamp is a precision instrument that will work without problems for many years with the appropriate
care. If you should nevertheless experience problems, please do not try to open the device to repair it yourself. Always leave
maintenance and repairs to the broncolor service centres.
13.
NOTE ON ENVIRONMENTAL PROTECTION
This product must not be disposed of with normal household waste at the end of its life, but must instead be taken to a recycling
point for electrical and electronic equipment. The materials can be recycled according to their markings. You can make an
important contribution to protecting the environment by reusing the product, recycling the basic materials or reprocessing
redundant equipment in other ways. Please ask your local authorities or our sales partners regarding the appropriate disposal
point.
