Brompton TESSERA M2, User Manual

Page: 235 / 296

TESSERA - V3.0 | USER M ANUAL - REV B | 15.5 - EDM X CONTROL
235
15.5 - EDMX CONTROL
15.5.1 - CONFIGURING THE PROCESSOR
FOR EDMX CONTROL
Both Art-Net and sACN (Stream ing ACN aka E1.31) are supported.
1. Connect an eDMX source to the Net port on the processor’s back panel (either directly or
via switch).
2. Go to the Live Control pipeline tile and select Art-Net or sACN from the Control Protocol
drop down m enu.
3. Ensure that the processor is in an eDMX com pliant IP Address and Subnet. This can be
changed in the Setting – Processor m enu. See Network on page 240 for m ore inform ation.
4. Enter a Start Address and universe for the processor. The Start Address will correspond
with the DMX address of the first param eter in the selected control profile and the
universe will determ ine which eDMX universe the processor will listen to.
5. Enable Live Control by double-clicking the Live Control pipeline tile or enabling from the
property editor.
If the eDMX signal is detected, the Live Control pipeline tile will light up green to indicate that a
source of live control has been detected and is enabled.
N OTE When connecting m ultiple processors to a single DMX over Ethernet source it is
recom m ended to m anage signal distribution with switches rather than using the
second port as a through port to daisy-chained processors.
N OTE When setting up Art-Net, the universe on Tessera LED Processors start from 0 rather
than 1.