Brompton TESSERA M2, User Manual

Page: 212 / 296

212
TESSERA - V3.0 | USER M ANUAL - REV B | 13.10 - DYNAM IC CALIBRATION (DYNACAL) USER INTERFACE
Fig 13.37 - Recognising Overbright (left) and Out-of-gam ut (right) Zebra Tool patterns
13.10.6 - FULL COLOUR AND LUMINANCE
ONLY CALIBRATION
Fig 13.38 - Full colour vs Lum inance only calibration slider
At the bottom of the Panel Output Colour Space is the Full colour - Lum inance only slider. This
slider can only be operated if the output colour space is either set to Achievable or Custom .
The slider allows the calibration to be set to either Full colour, Lum inance only or a percentage
m ix of the two by either using the slider or typing in a percent value.
When using Full colour calibration, the prim ary colours are defined by the Achievable / Custom
values set within the Panel Output Colour Space. This m eans that the prim aries will be looking
to reproduce the colour they have been set to as faithfully as possible (provided they are able
to). This creates the situation that if a green test pattern is being sent to panel when the ouput
colour space is set to achievable, it won't be using only the green LEDs at full brightness.