Comfort-Tilt
28
2. Cut the cable ties that secure the cable to the frame of the wheelchair (carefully note the
location of the cable ties and how the cable is routed around the frame of the wheelchair.)
3. Unscrew the tilt handle from the frame.
4. Remount the new handle assembly to the frame of the wheelchair using the screw
removed in step 3.
5. Route the new cable around the frame of the wheelchair the same as the previous one
and install new cable ties where necessary.
6. Attach the end of the cable into the actuator lever the same way removed in step 1.
7. Secure the cable clip to the end of the cable attached to the actuator and tighten the nut
on the bottom of the cylinder.
5.4
Rear Wheels
Removing and Installing the Rear Mag Wheels
1. Remove hubcap from wheel by turning counter clock-wise by hand
2.
Using a 5/8” combination wrench, loosen hex screw and locknut at axle of wheel
3. To install, reverse steps 1-2.
Ensure that the head of the bolt is towards the inside and the nut is on the outside
Note: The rear mag wheels can be mounted in 5 vertical positions on the mounting plate,
depending on the seat height required and combination of mag wheel selected.
The rear mag wheel can also be mounted horizontally along the mounting plate.
Hub Cap
Mag Wheel Tire
Hand-rim
Axle
