Brocade Communications Systems X6-4, Hardware Installation Manual, Page: 165 / 249

3. Enter firmwareShow to verify that the firmware version has been updated and that the versions are the same on the two CP
blades.
X6chassis:admin> firmwareshow -v
Slot Name Appl Primary/Secondary Versions Status
-----------------------------------------------------------
1 CP0 FOS v8.0.1 STANDBY
v8.0.1
2 CP1 FOS v8.0.1 ACTIVE *
v8.0.1
3 SX6 FOS v8.0.1
v8.0.1
4 SX6 FOS v8.0.1
v8.0.1
7 SX6 FOS v8.0.1
v8.0.1
8 SX6 FOS v8.0.1
v8.0.1
If you have one or more port or extension blades in the device, the Fabric OS automatically detects mismatches between the
active CP firmware and the blade's firmware and triggers the auto-leveling process. This auto-leveling process automatically
updates the application blade firmware to match the active CP blade. At the end of the auto-leveling process, the active CP and
extension blades will run the same version of the firmware.
4. Enter the chassisEnable command to enable all user ports in the chassis and enable a virtual, fabric-aware chassis.
5. Replace the chassis door. The door is required to meet EMI compliance.
6. Pack the faulty CP blade in the packaging provided with the new CP blade, and contact the switch supplier to determine the
return procedure.
Verifying blade operation
Perform the following tasks to verify operation of new blade:
1. Check the LED indicators on the blade's front panel. For information on interpreting LED patterns, refer to Interpreting control
processor blade LEDs on page 106.
2. Enter the following commands and note any error conditions:
• slotShow - Displays the current data on each slot in the system, including blade type, blade ID, status, Brocade model
name, and power usage.
• haShow - Displays control processor (CP) status.
• tempShow - Displays temperature reading of blades.
• sensorShow - Displays temperature reading of blades with fan and power supply status.
• errDump - Displays the entire system error log.
• errShow - Displays error log messages one at a time.
Refer to Using monitoring commands on page 115 and the Brocade Fabric OS Command Reference for output examples and
additional information on Fabric OS commands.
For more information about error messages, refer to the Brocade Fabric OS Message Reference .
Verifying blade operation
Brocade X6-4 Director Hardware Installation Guide
53-1004106-07 165