Brocade Communications Systems VDX 8770-4, Hardware Installation Manual, Page: 102 / 141

Time and items required
The replacement procedure for the cable management comb takes less than 5 minutes. A #1 Phillips screwdriver is required.
Removing a cable management comb
Complete the following steps to remove the cable management comb. Refer to the illustration provided with the procedure.
1. Remove the cables from the cable management comb and rearrange the cables around the comb.
2. Unscrew and save the four (4) screws holding the cable management comb to the chassis. Retain the screws. Support the cable
management comb to prevent it from falling.
3. Remove the cable management comb.
FIGURE 53 Removal and replacement of the cable management comb
Replacing a cable management comb
Complete the following steps to replace the cable management comb.
1. Position and tighten the four (4) screws to secure the new cable management comb to the chassis.
2. Arrange the cables in the cable management comb.
Removal and Replacement Procedures
Brocade VDX 8770-4 Hardware Installation Guide
102 53-1002563-10