Brocade Communications Systems ICX 7250, Hardware Installation Manual

Page: 99 / 119

2. Remove the new transceiver from the protective packaging.
3. Gently insert the transceiver into the slot until it clicks into place. Transceivers are keyed to prevent incorrect insertion.
NOTE
The location of the fiber-optic interface shown is for illustration purposes only. They may be in a slightly different
location on the device you are using.
FIGURE 58 Installing a transceiver
1. Transceiver
Cabling a fiber-optic transceiver
Perform the following steps to cable a fiber-optic transceiver.
1. Remove the protective covering from the fiber-optic port connectors and store the covering for future use.
NOTE
Before cabling a fiber-optic transceiver, Brocade strongly recommends cleaning the cable connectors and the port
connectors.
2. Gently insert the cable connector (a tab on each connector should face upward) into the transceiver connector until the tabs lock
into place.
3. Observe the link and active LEDs to determine if the network connections are functioning properly. For more information about
the LED indicators, refer to Observing LEDs on page 89.
Hardware Maintenance Schedule
Brocade ICX 7250 Switch Hardware Installation Guide
53-1003898-02 99