Installation tasks (Continued)
TABLE 10
Task number Task
Where to find more information
2
Unpack the device and all included accessories.
Items included with the EPS4000
on
page 39 section
3
Install the device on a desktop, or in an equipment rack.
on page 42
section
4
Once the device is installed, plug the device into a nearby
power source that adheres to the regulatory requirements
outlined in this manual.
on page 49
section
5
Verify that the device is working properly by plugging it
into a power source and verifying that it passes the self
test.
on page
49 section
Installation precautions
Follow all precautions when installing a device.
General precautions
DANGER
All fiber-optic interfaces use Class 1 lasers.
CAUTION
Do not install the device in an environment where the operating ambient temperature might
exceed 50°C (122°F).
CAUTION
Make sure the airflow around the front, sides, and back of the device is not restricted.
Lifting precautions
DANGER
Make sure the rack housing the device is adequately secured to prevent it from becoming
unstable or falling over.
DANGER
Mount the devices you install in a rack as low as possible. Place the heaviest device at the
bottom and progressively place lighter devices above.
Installation precautions
40
Brocade ICX 7250 Switch Hardware Installation Guide
53-1003622-02