supply. There is a RESET button next to the LEDs. There are port LEDs for each of the management
ports. Both the serial port and the out-of-band Ethernet management ports use RJ-45 connectors. The
slots for the RPS17 PSUs are covered with panels. These must be removed to install the PSU.
FIGURE 19
EPS4000 front panel
1. Management console serial port (RJ-45)
2. RPS17 PSU slots (three populated, one with cover on)
3. AC power cord input (C14)
4. PSU release Latch
5. Power cord clip
6. Integrated RPS17 PSU fan
7. PSU slot cover screws
8. Reset button - sets EPS4000 configuration to factory default
9. System status indicators
10.Out-of-band, Ethernet management port (RJ-45)
FIGURE 20
EPS4000 rear panel
1. DC power cable connectors 1-8
LEDs
The following figure shows the location of the LEDs on the EPS4000.
LEDs
Brocade ICX 7250 Switch Hardware Installation Guide
37
53-1003622-02