Brocade Communications Systems DCX Backbone, Hardware Installation Manual

Page: 32 / 167

Time and items required
Allow approximately one hour to unpack and install a device in a rack.
The following tools are required when installing the 14U Rack Mount Kit for Four-Post Rack:
• Torque screwdriver with #2 Phillips screwdriver tip
• Slotted (flat blade) screwdriver
• Hydraulic or assisted lift with a minimum raise of 140 cm (55 in.) and a minimum capacity of 113 kg (250 lb)
Parts list
The following table lists 14U Rack Mount Kit parts and quantities for different installations. Refer to the illustration following the table to
identify these parts.
TABLE 4 14U rack mount kit parts and quantities
Description Installation Quantity
Left rack mount shelf bracket (rail brackets may differ from ones shown in illustration) All 1
Right rack mount shelf bracket (rail brackets may differ from ones shown in illustration) All 1
10-32 x 5/8 in. (1.58 cm) panhead Phillips screw and washer (torque to 32 in-lb, [37 cm-
kg]) All 6
10-32 clip nut For rack rails with round holes 6
1/4-20 x 1/2 in. (1.27 cm) panhead Phillips screw with lock washer (torque to 80 in-lb [92
cm-kg]) For rack rails with round holes 16
10-32 retainer nut For rack rails with square holes 6
1/4-20 x 1/2 in. (1.27 cm) panhead Phillips screw with thread locker (torque to 80 in-lb [92
cm-kg]) For rack rails with square holes 16
3/8 in. (0.953 cm) alignment washer For rack rails with square holes 16
NOTE
Depending on the device and installation, not all the parts may be used on the device type.
Installing the 14U Rack Mount Kit for Four-Post Racks (XBR-DCX-0120 and XBR-DCX-0152)
Brocade DCX Backbone Hardware Installation Guide
32 53-1000685-24