Blade
Transceiver
Auto-negotiate/Fixed
Speeds supported(xGbps)
FC8-64
mSFP
Auto negotiate
2, 4, and 8.
FC16-32 and FC16-48
SFP+
Auto negotiate
2, 4, 8, and 16
FC16-32 and FC16-48
10-Gbps SFP+
Fixed
10
FCOE10-24
10-GbE SFP+ (only
optical)
Fixed
10
FC16-64
QSFP
Auto negotiate
4, 8, and 16. However, all the four
ports within a quad-SFP should be
of the same speed.
CR16-4/8
QSFP
Fixed
16
Time Required
The replacement procedure for a transceiver takes less than five minutes.
Items Required
• Replacement mSFP, SFP, SFP+, or XFP
• Optical transceiver extraction tool (for SFP, SFP+, and XFP transceivers)
Most Brocade switches and backbones come with a transceiver extraction tool and holster. The
extraction tool is designed to remove transceivers from switches and blades where the space is
limited.
FIGURE 31
Optical transceiver (SFP+) extraction tool
Removing an SFP+ transceiver
Complete the following steps to remove an SFP+ transceiver.
1. Remove any cables that are inserted into the transceiver. Use the extraction tool to open the cable
latching mechanism.
2. Using the hooked end of the tool, pull the bail (wire handle) away from its pivot point and out, sliding
the transceiver out of the switch or blade.
Time Required
104
Brocade DCX 8510-8 Backbone Hardware Reference Manual
53-1002180-08
Summary of Contents for DCX 8510-8
Page 1: ...53 1002180 08 19 September 2014 Brocade DCX 8510 8 Backbone Hardware Reference Manual ...
Page 22: ...Network manageability 22 Brocade DCX 8510 8 Backbone Hardware Reference Manual 53 1002180 08 ...
Page 34: ...Installing ICL cables 34 Brocade DCX 8510 8 Backbone Hardware Reference Manual 53 1002180 08 ...
Page 172: ...Danger Notices 172 Brocade DCX 8510 8 Backbone Hardware Reference Manual 53 1002180 08 ...
