Page 4
CJD1 SERIES
PREPARE THE HOOD
PREPARE THE HOOD
3
Remove
Damper/Duct
Connector
from inside
the hood. Set
connector
aside - with
mounting
screws and
parts bag.
5
Remove either
top or back
wiring knock-
out and install
approved
Electrical
Cable Clamp
(not included).
ELECTRICAL CABLE CLAMP
Non-Ducted Installation - Skip to “CONNECT
THE WIRING”.
6
Remove
Light Panel - held in place with (3) #8 screws
and (2) #8 screws. Disconnect light assembly wire harness
(white connector).
(3) #8 SCREWS
LIGHT
PANEL
(2) #8 SCREWS
The following
Steps (6 thru
13) are for
DUCTED
INSTALLATION
ONLY.
BAFFLE
7
Remove
Air
Chute - held in
place with one
(1) screw.
NOTE: Be
careful not to
disconnect any
wires.
9
Rotate baffle. Re-
insert baffle into air
chute (as shown) so
that baffle
tabs fit all
the way into
slots in
air chute. An audible
“click” will be heard
when fully installed.
This will close off
the air flow through
the non-ducted slots
on top of hood.
10 Re-install air chute, re-connect wire
harness, and replace light panel.
NOTE: Be careful not to trap wires
between
support fin and light panel.
AIR CHUTE
SLOTS
8
Remove
Baffle
from air chute.
BAFFLE
SUPPORT FIN
TABS
DAMPER/
DUCT
CONNECTOR
4
Remove
Wiring
Cover from
inside the hood.
Set cover and
mounting screw
aside.
WIRING
COVER
